Vacon DPD00109 Manual de Instalação descarregar pdf (Página 4)

4  vacon Keypad Remote Control Options

24-hour support 1-877-822-6606

Step 1. Preparing the Host Enclosure (XRKPM, XRKWM, and XRKMK)

Figure 1 on page 5 is a layout for remote keypad assembly mounting.

If you are fabricating a simple remote control station with this option, the following standard enclosure suggestions

are recommended: Hoffman #A1008CHNF or Hammond #1414N4PHI.

WARNING

SENSITIVE EQUIPMENT

The keypad contains static-sensitive components. It should be handled only by a static-safe installer,

using a grounded wrist strap.

Failure to observe this precaution may cause premature equipment failure.

DANGER

HAZARDOUS VOLTAGE

• Disconnect all power before servicing a drive unit or its components. WAIT 5 MINUTES until the DC

bus capacitors discharge.

• Ensure that any other power sources that may feed control logic have been disconnected.

• DO NOT short across DC bus capacitors or touch unshielded components or terminal strip screw

connections with voltage present.

• Install all covers before applying power or starting and stopping the drive.

• The user is responsible for conforming to all applicable code requirements with respect to grounding

all equipment.

• Many parts in this drive, including printed circuit boards, operate at line voltage. DO NOT TOUCH.

Use only electrically-insulated tools.

Before servicing any drive.

• Disconnect all power.

• Place a “DO NOT TURN ON” label on the drive disconnect.

• Lock the disconnect in the open position.

Failure to observe these precautions will cause shock or burn, resulting in severe personal

injury or death.

1 2 3 4 5 6 7 8 9 ... 17 18

Sem comentários

Vacon DPD00109 Manual de Instalação Página 4